SLIDE FURNACE
MTG. PLATE TABSALL THE WAY BACK
ONTO MTG. PLATE
SECURE FURNACE
WITH 2 FASTENERS AT FRONT
CORNER HOLES
Knockout Over Holes
SUPPLY AIR DUCT
Figure 19. “A”, “B”, & Platinum
Cabinet Furnaces
added protection against leaks, coat the flash- ing plate and fasteners with approved roofing compound.
If flashing mounted on 12 degree angle is used it may be necessary to adjust the angle to match the roof pitch; (1/12 - 4/12 maximum).
12.INSTALLATION OF TRANSIT- MODE VENTING SYSTEM
MANUFACTURED HOME FACTORY
a. Furnace to be installed per furnace installa- tion manual.
b. Roof Jack to be selected from Table 5 of these instructions.
FUEL
LINE HOLES
MTG. PLATE TABS
SECURE FURNACE WITH 2 FASTENERS
AT FRONT CORNER HOLES
SUPPLY AIR DUCT
SLIDE FURNACE
ALL THE WAY BACK ONTO MTG. PLATE
c. Roof Jack (less upper Roof Jack crown), with weather cap to be installed as described under Install Roof Jack.
d. Upper Roof Jack crown to be stored in a prominent location inside manufactured home until
e. The four warning tags supplied must be installed as follows:
• | To weather cap |
• | To fuel line connection point (Gas) or |
| furnace burner (Oil) |
Figure 20. “A” Cabinet Furnace on 911969
Coil Cabinet (Non-Platinum Series)
Secure Roof Jack with |
appropriate fasteners |
after connecting to |
furnace |
Roof |
Caulk under roof |
flashing to prevent |
water leakage |
Ceiling |
Optional #901943 |
Ceiling Trim Ring |
or #902521 |
• | To furnace flame observation door (Gas |
| or Oil) |
• | To furnace wall thermostat |
MANUFACTURED HOME SITE
a.
b. Place upper Roof Jack (crown) on to the flue pipe assembly. Be sure inside flue pipe attaches over inner flue pipe. Be sure outer Roof Jack pipe fits over outer pipe. Secure in place using three (3), #10, 1/2" sheet metal screws removed in step #a. Do not use the same holes which secured the rain cap in place.
Figure 21. Flat Roof
Secure lower roof jack section with no. 10 S.M. screws
Roof
Caulk under roof flashing to prevent water leakage
Upper Roof
Jack Section
Optional
Flashing
Secure flashing with appropriate fasteners
Ceiling
Figure 22. | Figure 23. Pitched Roof |
14