Setup and assembly
Adjusting the tilt base
The Expansion Module stand provides a continuous tilt adjustment so the tilt angle matches the IP Phone stand angle while accommodating variations in the desk surface. A clamp mechanism is used to unlock and lock the foot stand angle.
CAUTION
Do not over tighten the wheel on the Expansion Module.
The Expansion Module is tightened by spinning the wheel clockwise and loosened by spinning the wheel
Turn the wheel on the back right side (if viewed from the front) of the Expansion Module to loosen the stand hinge. Adjust the angle of the IP Phone using the tilt lever. When the IP Phone is set to a preferred angle, turn the wheel on the back of the Expansion Module to tighten the stand hinge and lock the stand at the same angle as the attached IP Phone.
15
