Nortel Networks 8672ATMM manual Installing an MDA, Task and estimated time cont’d Estimated time

28Media Dependent Adapter installation for the 8672ATME and 8672ATMM modules

Table 2

Task and estimated time (cont’d.)

Task	Estimated time
Aligning the MDA with the front portion of the module and	2–5 minutes
mounting the posts
Seating MDA and tightening the screws and the label	2–5 minutes
Removing dust plugs and caps	2–5 minutes
Total time required	10–22 minutes

Installing an MDA

This procedure describes how to install an MDA on Ethernet Routing

Switch 8600.

CAUTION

Risk of service loss

You cannot hot-swap an MDA. You must remove the 8672ATME or 8672ATMM module, install the MDA, and then reinstall the module. For more information about removing and installing the 8672ATME and 8672ATMM modules, see Ethernet Routing Switch 8600 Installation — Modules, NN46205-304.

Procedure steps

Step Action

1Lay the 8672ATME or the 8672ATMM module on a flat, static-free surface.

2Lift the cover out of the MDA slot by unscrewing the two screws and lifting the cover straight up. Set the cover aside for possible future use.

Nortel Ethernet Routing Switch 8600

Installation — Media Dependent Adapters for the 8672ATME and 8672ATMM Modules

NN46205-316 01.01 Standard

30 May 2008

Copyright © 2008 Nortel Networks