Nortel Networks BCM50 2.0 manual Administration telset interfaces, Initial setup telset menus

11

Administration telset interfaces

You can use Business Element Manager or you can use the Telset interface to administer your BCM50 system. The telset configuration is a tool that is used for system configuration if there is no network connection to your BCM50, or for quick configuration changes, such as changing features in a DN record or updating one of the speed dial lists. Administration telset interfaces are accessible only by a user with an Installer level of telset user privileges. These menus are used at initial startup or to make changes to security-sensitive system settings.

•“Initial setup telset menus” on page 11

•“Using FEATURE 9*8 for initial configuration” on page 12

Initial setup telset menus

The initial telset menus are used during the initial configuration of your system. The user requires Installer (Administrator) level of password to use these menus. The following three features must be done within 15 minutes of power up:

FEATURE	(**PROFILE)	should only be run at the initial set up if the Startup profile did
**7763453		not properly set the country profile on your system and the
		Element Manager is not accessible to perform this task.
FEATURE	(**DIALPAD)	allows you to change how the system receives Q and Z in
**3425723		the telset interface.
FEATURE	(**STARTUP)	should only be run at the initial set up if the Startup profile did
**7827887		not set the telephony profile to the correct setting and the
		Element Manager is not accessible to perform this task. Note
		that using this interface returns your system to the default
		state

Figure 1 Menus for profiles and dialpad function for startup programming

BCM50 Telset Administration Guide