Nortel Networks NN46200-301 manual Accessing the Nncli

		Command line interfaces 9
Table 1
NNCLI command modes
Command	Prompt	Mode	Command/mode
mode		name	to enter or exit mode
User EXEC	ERS-8300:5>	Exec	Default mode
			when NNCLI is started
			logout to exit
Privileged	ERS-8300:5#	privExec	enable to enter
EXEC			from User EXEC mode
			disable to exit
			to User EXEC mode
Global	ERS-8300:5(config)#	config	configure to enter
Configuration			from Privileged EXEC
			mode
			exit to exit
			to Privileged EXEC
			mode
Interface	ERS-8300:5(config-if)#	config-if	interface to
Configuration			enter from Global
			Configuration mode
			exit to exit
			to Global Configuration
			mode

Accessing the NNCLI

When you first power up the Ethernet Routing Switch 8300, the default interface is the Ethernet Routing Switch 8300 CLI. To switch from the CLI to the NNCLI, you must change the NNCLI boot flag to true and save the boot configuration file using the following commands:

ERS-8310:5#config boot flags nncli true

ERS-8310:5# save boot

You must reboot the switch for this change to take effect. After you reboot the switch, access the NNCLI using Telnet, rlogin, or the local console port. You can log in to the switch using your password and the default privilege password nortel.

Use the following commands to:

•log in to the software using the default user name and password

•access Global Configuration mode

Login: xxxxx

Password: xxxxx ERS-8310:5> enable

Nortel Ethernet Routing Switch 8300

Installation — AC Power Supply

NN46200-301 03.01 Standard

4.027 August 2007

Copyright © 2007, Nortel Networks