Troubleshooting
Problem |
|
Engine will not start | SOLUTION: A |
Low/Surging pressure or no water flow | SOLUTION: B,C,D,E,F,G |
No chemical injection | SOLUTION: H,I,J,K |
Cause | Solution |
A- Engine starting instructions not followed | See engine manual for starting instructions |
B- Insufficient water supply | See water supply section of this manual |
C- Plugged pump inlet filter | See maintenance section of this manual |
D- Nozzle in low pressure position | Pull nozzle back for high pressure |
E- Plugged nozzle orifice | Remove nozzle orifice, check for blockage |
F- Worn nozzle orifice | Replace nozzle orifice |
G- Leak in pressure hose | Replace pressure hose |
H- Nozzle in high pressure position | Push nozzle forward for low pressure |
I- Back pressure from extra long pressure hose | Use standard length hose |
J- Leak in chemical siphon hose | Replace hose – use hose clamps if necessary |
K- Chemical strainer not submerged | Make sure strainer is completely submerged |
Specifications and Accessories
Specifications
157471
PSI | 2000 |
GPM | 2.0 |
Max Water Temp | 140°F |
Dimensions (inches) | 16.75 x 13.5 x 19.75 |
L x W x H |
|
Weight | 50 lbs |
157472 |
|
PSI | 2400 |
GPM | 2.0 |
Max Water Temp | 140°F |
Dimensions (inches) | 16.75 x 13.5 x 19.75 |
L x W x H |
|
Weight | 52 lbs |
Accessories
Wheel kit, Item# 157473
Call Northern Tool & Equipment,
The manufacturer reserves the right to make improvements in design and/or changes in specifications at any time without incurring any obligation to install them on units previously sold.
Any Questions, Comments, Problems or Parts Orders
Call Northstar Customer Service
16
