Numark Industries DM1001X/DM1002X Rear Panel Diagram, Rear Panel Inputs and Outputs

DM1001X/DM1002X

DM1001X/DM1002X REAR PANEL DIAGRAM...

7 7

1 2

3 4 5 6 5 6

REAR PANEL: INPUTS AND OUTPUTS

1.Power Connection. Plug your power adapter in here. See safety precautions on page 3 for proper treatment of the power cord.

2.GND is the grounding lug for all turntables. Always use this connection (your turntable cable should have a grounding wire).

3.The Stereo Main Outputs are low-impedance RCA connectors controlled by the Master fader.

4.The Record Outputs are designed to be hooked up to your tape deck’s input jacks.

5.The Phono Inputs use unbalanced RCA jacks. Your input signal is fed directly to your mixer’s high- quality RIAA phono pre-amplifiers so use this position only for moving magnet cartridges. Line level sources will overload the sensitive phono pre-amps and will sound very bad, so always be sure to toggle the line/phono switch over to line before connection of line sources.

6.The Phono/Line Inputs are unbalanced RCA jacks. The Line Input is selected with the Line/Phono Input switch above it.

You can connect stereo audio from HiFi VCRs, cassette and reel-to-reel tape decks, DAT machines, CD players, laser discs, tuners, even synthesizers or other mixing consoles.

N O T E : Plug mono audio sources into both Left and Right inputs using a “Y” cable connector.

Warning: make sure the LINE/PHONO input switch is set to line before playing any line input level devices through your mixer

8.Line/Phono Input switch. Use this to allow line level equipment to be plugged into your phono inputs.

Numark - The Proven Leader in DJ Technology

©1998 Numark Industries 8 http://www.numark.com