DM900EX

REAR PANEL: INPUTS AND OUTPUTS

(Please refer to diagram on page 7)

1.Power Input. Plug your external power supply into here. See safety precautions on page 3 for proper treatment of the power cord.

2.GND is the grounding lug for all turntables. Always use this connection (your turntable cable should have a grounding wire).

3.Phono Inputs on Channels 1, 2 and 3 use unbalanced RCA jacks. Your input signal is fed directly to the D M 9 0 0's high-quality RIAA phono pre-amplifiers so use this position only for moving magnet cartridges. Line level sources will overload the sensitive phono pre- amps and will sound very bad, so always be sure to toggle the line/phono switch over to line before connection of line sources.

4.Channels 1 & 2 Line Inputs are unbalanced RCA jacks. The Line Input is selected with the toggle switch on the front panel.

You can connect stereo audio from HiFi VCRs, cassette and reel-to-reel tape decks, DAT machines, CD players, laser discs, tuners, even synthesizers or other mixing consoles.

N O T E : Plug mono audio sources into both Left and Right inputs using a “Y” cable connector.

5.Line/Phono Input switch. Use this to allow line level equipment to be plugged into your phono inputs giving you a total of 8 line input options.

6.The Tape Outputs are low-impedance unbalanced RCA jacks which output the program mix and allow you to connect any recording device.

7.The Stereo Master Outputs are low-impedance RCA connectors controlled by the Master fader.

Numark - The Proven Leader in DJ Technology

©1998 Numark Industries

8

http://www.numark.com

Page 8
Image 8
Numark Industries DM900EX owner manual Rear Panel Inputs and Outputs