FRONT PANEL FEATURES
1.Crossfader: This replaceable crossfader fades between channels assigned to CFA and CFB. The fader can be replaced by a Numark
2.EQ Kills: Eliminates High, Mid, or Low frequencies for a unique effect. Each set of three switches will only affect audio routed through the crossfader.
3.3 Audio Channels: The mixer contains three audio channels which are described in detail in the Audio Channel section in this manual.
4.Headphone Monitoring: This section contains the CUE GAIN knob to adjust the headphone volume, and the CUE BLEND knob to mix between the master and the channels selected by the PFL buttons on each channel. Pressing the CUE BLEND button activates a split cue mode.
Push the knob to engage a split cuing mode which sends all audio channels with the CUE Assign button engaged to the left side of the headphones and the MASTER output to the right side of the headphones. This mode is an excellent way to mix when booth monitoring is not available.
5.Microphone Adjustments: The MIC GAIN knob controls the level of the microphone input on the front panel. There are also a MIC BASS knob and a MIC TREBLE knob to control the sound of the microphone input.
To turn the microphone on, move the MIC switch to the ON position.
6.Output Levels: The master level output is controlled by the MASTER knob. The booth output level is controlled by the BOOTH knob.
7.Beat Synced Effects: The mixer has a highly customizable
8.Microphone Input: This 1/4" input is for the microphone controlled by the Microphone Adjustments (#5).
9.Headphone Output: Connect your headphones to this 1/4” output.
10.Crossfader Slope Adjustment: This knob adjusts the slope of the crossfader from a smooth fade (mixing) to a sharp cut (scratching).
11.Cue Tone: This knob adjusts the tone of the headphone output without affecting any other output. This can be used to help mix while in a loud environment.
12.Cross Fader Start: Both sides of the crossfader have a FADER START switch which can be used to trigger external devices which have a fader start input.
AUDIO CHANNEL SELECTION
1. Input Selector: Selects the
desired input source.
2.GAIN Knob: Adjusts the channel audio level
and
3. EQ Knobs: Adjusts the treble, mid and bass frequencies. The level of each frequency can be set all the way down to zero (killed).
4.PFL Cue: Sends the pre- fader level of the audio to
the cue section for headphone monitoring.
5.Crossfader Assign: Routes
the audio in the channel to one side of the crossfader. The OFF position bypasses the crossfader.
6.Channel Line Fader: Controls the level of the output signal post EQ into
the crossfader (if assigned) or MASTER.
4
