MOUNTING REFLECTOR AND GRILLE
1.Refer to Figure 3. Place reflector in the opening in the center of the grille. The notches in the reflector should fit over the pegs on either side of the opening. Insert plug from lamp socket into white receptacle on wiring compartment .
2.Place 1" screw, provided, through the center hole in the reflector and thread it into the hole in the mounting bracket running across the housing. Tighten the screw just enough to hold the grille firmly against the ceiling.
3.Install a 100 watt maximum, type
4.Refer to Figure 4. Snap lens into position in center of grille. To remove the lens for relamping, gently pry along the side of the lens with a screwdriver to disengage the snap in tabs while pulling down on the lens.
LENS
FIGURE 4
Product specifications subject to change without notice. 4820 Red Bank Road, Cincinnati, Ohio 45227 Printed in Canada, Rev. 5/06, Part No. 88581
