NuTone nm200, nc300 Preset Radio Stations, Scan Mode, Audio Settings Volume, Tone

models nm200 • nc300

Preset Radio Stations

To preset radio stations:

1.Press POWER to turn on the music.

2.Select FM or AM. See Music Settings/Music Source for instructions.

3.Use TUNE UP or TUNE DOWN to find a station. See Tune the Radio section for seek and scan functions.

4.Simultaneously press TUNE UP and TUNE DOWN to enter Store Preset mode. The display shows PRESET and a preset number.

5.If you don’t want to assign a preset number, wait 5 seconds and your selected radio station will automatically be assigned to the preset number that is displayed. If you want to select the preset number, press the PRESET button repeatedly to cycle through numbers 1-8 until you reach the preset number you want.

6.Wait 5 seconds. The display updates to show the new station for the selected preset number.

Note: This activity can be cancelled at any time during the process by pressing TUNE UP and TUNE DOWN simultaneously again, and no new preset is stored.

Scan Mode

Two scan modes are available. The scan mode for the room stations is set at the master. The two scan modes are identified below. To set your scan mode:

•Scan 1—Allows the Indoor/Outdoor Remote Stations to scan through the four music sources (AUX, AM, FM, CD). On radio bands AM and FM, Scan 1 scans through the preset radio stations: AM 1-8 and FM 1-8. See Music Settings/Radio

Settings for information on how to preset radio stations.

•Scan 2—Allows Indoor/Outdoor Remote stations to scan through the four music sources (AUX, AM, FM, CD.) On radio bands AM and FM, Scan 2 scans all strong stations before moving on to the next source.

Page 

To set the Scan Mode:

To change the scan mode, simultaneously press and release PRESET and SOURCE again. The display shows either Scan1 or Scan2.

Note: Exit out of scan mode by pressing PRESET and SOURCE or waiting for the display to show the clock time again.

Audio Settings

Volume

•Music—Adjusts the volume for system music.

•Master Station—Adjusts the volume for the speaker on the

Master Station only.

•Intercom—Adjusts the volume for the system intercom.

Tone

•Loudness

•Treble

•Bass

To change volume and tone settings:

1.Press POWER to turn on music. The system defaults to music volume. Use VOLUME UP and VOLUME DOWN to adjust the music volume from 0-29. All other audio settings return to music volume after 5 seconds.

2.Press TONE. Master Volume appears. This controls the volume for the Master Station speaker only. Use VOLUME UP and VOLUME DOWN to adjust the Master Volume from 0-29.