models Nm200WH • Nm200Al Page 2Connect each colored conductor to its respective screw
terminal. The screw terminals are marked with the appropriate
wire colors. Note: Some screw terminals have more than one
wire connected to them.
Mount each remote station to its mounting ring using the two
screws provided with each NM200 remote station
Nps200WH outdoor remote station
Ateachoutdoor remotestationlocation, stripapproximately4
inchesofjacketfrom theCAT5wire andseparatethecolored
conductors. Strip ½ inch of insulation from each conductor and
connect each colored conductor together using wiring wire
nuts.
Note: Some wires are doubled up when connected to the remote
station. Mount the outdoor remote station to the housing using
the 2 screws provided with the remote station.
iNstAlliNg tHe NA300mc volume coNtrol
At each NA300MC location strip approximately 4 inches of
jacketfromwires andseparatecolored conductorsfrom each
other. Wire nut each colored conductor to its respective wire as
showninthenextgure.
Connect 18 gauge speaker cable wires to the corresponding
terminals of the satellite speakers. Mount the NA300MC to the single
gang box using the two screws provided with the volume control.
coNNectiNg tHe iA30WH Audio WAll plAte
Use the labels provided to mark respective cables. Connect
the cables to the IA30WH audio wall plate and mount the plate
usingthetwo screws provided. Please see gure below and
refer to the NuTone IA30WH installation guide for more detailed
instructions.
iNstAlliNg tHe door stAtioNs
Ateach door station location, strip approximately 4 inches of
jacketfrom wire and separate colored conductors from one
another. Strip ½ inch of insulation from conductors. Cut each
shielddrainwireat jackettopreventthem fromtouchingeach
other. Terminate yellow and orange wires to the screw terminals
on the chime pushbutton (if equipped). Connect the red and black
wires to the red and black wires on the speaker respectively.
Refertogurebelow.Mountdoorstation tohousingusingthe
two screws provided with the door station.
from the CAT5 wire and separate the colored conductors from
one another. Strip ½ inch of insulation from each conductor as
shown: