INSTALL THE DUCTWORK
NOTE: To reduce the risk of fire, use only metal ductwork.
1.Decide where the ductwork will run between the hood and the outside.
2.A straight, short duct run will allow the hood to perform most efficiently.
3.Long duct runs, elbows, and transitions will reduce the performance of the hood. Use as few of them as possible.
4.Install a roof or wall cap. Connect 6" round metal ductwork to cap and work back to- wards hood location. Use duct tape to seal the joints between ductwork sections.
INSTALL MOUNTING
BRACKETS
1.Construct wood wall framing that is flush with interior surface of wall studs.
Make sure:
a)the framing is centered over installation location.
b)the height of the framing will allow the mounting brackets to be secured to the framing within the dimensions shown.
2.After wall surface is finished, secure mount- ing brackets to framing at dimensions shown, using screws provided.
INSTALL THE HOOD
1.Hang the hood from the brackets through the rectangular
The bottom of the hood should be 24" to 30" above the cooking surface.
2.Height adjustment screws provide vertical adjustment.
3.Depth adjustment screws provide hori- zontal adjustment.
4.Secure the hood with mounting screws (4.8x38mm). Use drywall anchors, provided, if wall studs or framing are not available.
ROOF CAP
| 6” ROUND DUCT |
DECORATIVE | WALL |
FLUE | CAP |
HOOD | 6” ROUND |
| |
| ELBOW |
24” TO 30” ABOVE COOKING SURFACE
FRAMING BEHIND DRYWALL
|
|
| 4 | 15 |
|
|
|
|
|
|
| / |
|
| |
|
|
|
|
| 16" |
|
|
|
|
|
|
| 4 | 15 |
|
|
|
|
|
|
| / | |
|
|
|
|
|
|
| 16" |
43 | / |
|
|
|
|
|
|
| 5 | 8" |
|
|
|
|
|
|
| to | / |
|
|
|
|
|
| 49 |
|
|
|
| |
|
|
| 5 | 8" |
|
| |
|
|
|
|
| above | ||
|
|
|
|
|
|
| cooktop |
435/8"= bottom of hood 24" above cooktop 495/8"= bottom of hood 30" above cooktop
MOUNTING | RECTANGULAR |
SCREWS | CUTOUTS |
(4.8x38mm) | MOUNTING |
| |
| BRACKETS |
WALL |
FRAMING |
DEPTH ADJUSTMENT |
SCREWS |
HEIGHT |
ADJUSTMENT |
SCREWS |
- 5 -