WIRING
Note: This range hood must be properly grounded. The unit should be installed by a qualified electrician in accordance with all applicable national and local electrical codes.
1.Remove the wiring box cover. Remove a knockout from the wiring box.
2.Secure the conduit to the wiring box through a conduit connector.
3.Make electrical connections. Connect white to white, black to black and green to green.
4.Replace wiring box cover and screws. Make sure that wires are not pinched between cover and box.
WIRING BOX
COVER
CONNECT DUCTWORK
1.Use screws (4.8x38mm) and wall anchors (provided) to secure flue mounting bracket to the ceiling or wall as shown.
2.Use 6" round metal duct to connect the duct collar on the hood to the ductwork above.
3.Use duct tape to make all joints secure and air tight.
FLUE
MOUNTING
BRACKET
MOUNTING SCREWS (4.8x38mm)
DECORATIVE
FLUE
DUCT TAPE
6" ROUND
METAL DUCT
- 6 -