NuTone Prepare Hood Location, Prepare The Hood, ALLURE WS2 SERIES RANGE HOOD, Page, 3¼” X 10”

ALLURE® WS2 SERIES RANGE HOOD

PREPARE HOOD LOCATION

ROOF CAP

3¼" X 10" (For vertical discharge)

SOFFIT
	HOUSE WIRING
CABINET	(Top or Back of hood)

WALL CAP

HOOD

24" - 30" ABOVE	3¼" X 10" DUCT
COOKING SURFACE
	(For horizontal discharge)

1	Determine whether hood will discharge vertically (3¼” x 10”),
	horizontally (3¼” x 10” only), or non-ducted. For vertical or
	horizontal discharge, run ductwork between the hood location
	and a roof cap or wall cap. For best results, use a minimum
	number of transitons and elbows.
2	Use diagrams, below, for proper placement of ductwork and
	electrical cutout in cabinet or wall. For a non-ducted installation,
	DO NOT cut a duct access hole.

HOOD MOUNTING SCREWS (4)			3¼” X 10”
			VERTICAL DUCTING
	1315/16" (30" hood)
		1315/16" (30" hood)
	1615/16" (36" hood)
	1915/16" (42" hood)	1615/16" (36" hood)
	CABINET FRONT	1915/16" (42" hood)

7½"

CABINET BOTTOM
	5¼"	5¼"	2"	10½"
	VERTICAL DUCT
5"	ACCESS HOLE
1¼"				1½"
			ELECTRICAL
WOOD SHIMS	CENTER		ACCESS HOLE
(recessed-bottom			(in cabinet bottom)
		LINE
cabinets only)
WOOD SHIMS			3¼” X 10”
(recessed-bottom			HORIZONTAL DUCTING
cabinets only)	CABINET FRONT
			1/8" ¾"

3¾"	HORIZONTAL DUCT
	ACCESS HOLE
CABINET
	5¼"	5¼"
BOTTOM
1315/16" (30" hood)		7½"
		1315/16" (30" hood)
1615/16" (36" hood)
		1615/16" (36" hood)
1915/16" (42" hood)
		1915/16" (42" hood)
HOOD
MOUNTING	CENTER		ELECTRICAL
			ACCESS HOLE
SCREWS (4)	LINE
			(in wall)

3 Run house wiring between service panel and hood location.

Page 2

PREPARE THE HOOD

FILTERS

1 Remove tape holding Filters in place. Pull down on filter tabs or finger holes and lift filters out. Set filters aside.

TEFLON®-

COATED

BOTTOM

COVER

(Held in

place with 2 screws)

2 Remove Teflon® -coated bottom cover from hood. Set cover and mounting screws aside.

Teflon® is a registered trademark of DuPont.

DAMPER/

DUCT

CONNECTOR

3 Remove Damper/Duct Connector from inside the hood. Set connector aside - with mounting screws and parts bag.