NuTone warranty ALLURE WS2 SERIES, Range Hood, Page, Ducted Installation - Skip to Step

	ALLURE® WS2 SERIES
	RANGE HOOD
	Page 3
PREPARE THE HOOD	PREPARE THE HOOD

ELECTRICAL

CABLE CLAMP

4 Remove either top or back wiring knockout and install approved Electrical Cable Clamp.

Ducted Installation - Skip to Step 11.

The following Steps (5 thru 10) are for

NON-DUCTED INSTALLATION ONLY.

6	Remove Air
	Chute - held in
	place with one
	(1) screw.

NOTE: Be careful not to disconnect any wires.

7	Remove Baffle
	from air chute.
	Tabs will
	disengage
	from Slots.

AIR CHUTE

BAFFLE

SLOTS TABS

(3) #8 SCREWS
(2) #8 SCREWS	LIGHT
	PANEL

5 Remove Light Panel - held in place with (3) #8 screws and (2) #8 screws. Disconnect light assembly wire harness

(white connector).

SUPPORT FIN

8 Rotate baffle. Reinsert baffle into air chute (as

shown) so that baffle fits all the way into into air chute. An audible “click” will be heard when fully installed.

This will direct air flow through the non-ducted slots on top of hood.

9 Re-install air chute and screw,

re-connect wire harness, and replace light panel.

NOTE: Be careful not to trap wires between Support Fin and light panel.