nVIDIA N61P/N61S/N61V

User's /Manual

 

 

2.5Connecting Peripheral Devices

2.5.1Floppy and IDE Disk Drive Connectors

Each of the IDE port connects up to two IDE drives at Ultra ATA 66/100/133 mode by one 40-pin, 80-conductor,and 3-connector Ultra ATA/66 ribbon cables.

Connect the single end (blue connector) at the longer length of ribbon cable to the IDE port of this board, the other two ends (gray and black connector) at the shorter length of the ribbon cable to the connectors of your hard drives.

Make sure to configure the “Master” and “Slave” relation before connecting two drives by one single ribbon cable. The red line on the ribbon cable must be aligned with pin-1 on both the IDE port and the hard-drive connector.

The FDD connector connects up to two floppy drives with a 34-wire, 2-connector floppy cable.Connect the single end at the longer length of ribbon cable to the FDD on the board, the two connectors on the other end to the floppy disk drives connector. Generally you need only one floppy disk drive in your system.

The red line on the ribbon cable must be aligned with pin-1 on both the FDD port and the floppy connector.

2.5.2 Serial ATA Connectors

Each SATA connector serves as one single channel to connect one SATA device by SATA cable.

2.5.3 PCI and PCI Express slots

Install PCI Express X16 graphics card into slot “PCIEXP1”.

Install PCI Experess X1 card into slot "PCIE". (for nVIDIA N61(V2.0) only) Install PCI cards into slots “PCI1” and/or “PCI2”.

- 11 -