nVIDIA N61P/N61S/N61V | User's /Manual |
|
|
Chapter 2 Hardware Setup
2.1 Choosing a Computer Chassis
The mainboard and its component layouts illustrated in this chapter were 
based mainly on model “nVIDIA N61(V1.0)”, unless specifically stated.
•Choose a chassis big enough to install this mainboard.
•As some features for this mainboard are implemented by cabling connectors on the mainboard to indicators and switches or buttons on the chassis, make sure your chassis supports all the features required.
•If there is possibility of adopting some more hard drives, make sure your chassis has sufficient power and space for them.
•Most chassis have alternatives for I/O shield located at the rear panel. Make sure the I/O shield of the chassis matches the I/O port configuration of this mainboard. You can find an I/O shield specifically designed for this mainboard in its package.
2.2 Installing Mainboard
Most computer chassis have a base with many mounting holes to allow the mainboard to be securely attached, and at the same time, prevent the system from short circuits. There are two ways to attach the mainboard to the
chassis base: (1) with studs, or (2) with spacers. Basically, the best way to attach the board is with
studs. Only if you are unable to do this should you attach the board with spacers. Line up the holes on
the board with the mounting holes on the chassis. If the holes line up and there are screw holes, you
can attach the board with studs. If the holes line
up and there are only slots, you can only attach with
spacers. Take the tip of the spacers and insert them
into the slots. After doing this to all the slots, you can slide the board into position aligned with slots. After the board has been positioned, check to make sure everything is OK before putting the chassis back on.
Always power off the computer and unplug the AC power cord before adding or removing 
any peripheral or component. Failing to do so may cause severe damage to your mainboard and/or peripherals. Plug in the AC power cord only after you have carefully checked everything.
To install this mainboard:
1.Locate all the screw holes on the mainboard and the chassis base.
2.Place all the studs or spacers needed on the chassis base and have them tightened.
3.Face the mainboard’s I/O ports toward the chassis’s rear panel.
4.Line up all the mainboard’s screw holes with those studs or spacers on the chassis.
5.Install the mainboard with screws and have them tightened.
To prevent shorting the PCB circuit, please REMOVE the metal studs or spacers if they are 
already fastened on the chassis base and are without
- -