OPERATION INSTRUCTIONS
A. BREWING COFFEE
1.Remove brew basket from brewer.
2.Place one (1) standard commercial filter (9.5 inch diameter) into brew basket.
3.Put required amount of coffee grounds into filter and shake brew basket to level off coffee grounds.
4.Return brew basket to brewer.
NOTE: Brew basket is designed to click into place when properly installed. This action secures the brew basket to the cabinet.
5.Place appropriate EMPTY thermal carafe into position below the brew basket.
6.Press the BREW (FULL POT) button for full pot volume or the BREW (HALF POT) button for half pot volume.
NOTE: The corresponding light above the chosen BREW button will blink for the duration of the brew cycle. When light has stopped blinking, the brew cycle is complete and it is safe to remove the carafe.
7.After brewing is complete, remove brew basket and discard used coffee grounds and filter.
8.Rinse brew basket and return to brewer.
Filter/Coffee
Placement
Brew Basket
Figure 3
Brew Basket Illustration
B. CANCELLING A BREW CYCLE
To cancel a brew cycle that is in process, press the ON/OFF BREW CANCEL button located on the front control panel. When canceling a brew cycle, water is shut off to the spray head, but the brew basket will continue to drain until depleted.
C. CUP DRAW FROM SAFTEY FAUCET
CAUTION: WATER FROM SAFETY FAUCET IS HOT
To draw a cup of hot water from the safety hot faucet (red button located on the front panel of the brewer):
1.Place an empty cup directly under the
2.Push the red button down and forward to start the flow of hot water.
3.When finished, release button. Button will return to original position and hot water will stop flowing.
Figure 4
Safety Faucet Illustration
