SERVICE INSTRUCTIONS
A.ADJUSTING HOT TANK THERMOSTAT
Whenever thermostat adjustment becomes necessary, complete the following procedure:
1.Disconnect power cord from electrical outlet.
2.Remove (2) screws and rear panel (see figure 5).
3.Use a bladed screwdriver to adjust the thermostat knob (see figure 5). Turn clockwise for hotter water temperature and counter clockwise for cooler water temperature.
4.Replace rear panel and (2) screws.
5.Plug power cord into electrical outlet and follow steps
Rear Switch Plate
Screws (2)
3/8” Quick Tube | On/Off main | |
power switch | ||
Connect | ||
| ||
| IEC Cord | |
| Receptacle | |
Thermostat |
| |
Adjustment Knob |
| |
| Rear Panel |
Figure 5
Figure 5
Thermostat Adjustment Illustration
Thermostat Adjustment Illustration
B.CLEANING THE SPRAYHEAD
Over time mineral build up may develop around the
(6) spray holes on the spray head which may lead to pot volume variances. Periodic inspection and cleaning of the spray head is recommended.
1. | Turn spray head counter clockwise a quarter |
| turn until it stops (see figure 6). |
2. | The spray head and the brew basket rail will |
| drop straight down to remove. |
3. | Remove gasket from spray head when cleaning. |
4. | Reassemble spray head and brew basket rail |
| using reverse procedure. Make sure spray |
| head detents (clicks) into place when |
| reassembling. |
Brew Basket Rails
Spray Head Gasket
Spray Head
Hot Water
Faucet Outlet
Opening
Figure 6
Spray head removal Illustration
C.REMOVING HOT TANK ASSEMBLY FROM CABINET ASSEMBLY
1.Turn the main water supply to brewer OFF.
2.Disconnect the power cord from both the electrical outlet and the IEC plug located at the rear of the brewer (see figure 5).
3. Disconnect 3/8 inch supply tube from quick tube connect |
| |
Cover | ||
(see Figure 5). |
| |
| ||
NOTE: | If hot tank is full, water will dribble from the |
|
| external tube fitting. It is recommended that |
|
| the fitting be plugged with the provided 3/8 |
|
| inch plug. |
|
4.Remove cover from cabinet assembly.
5. | Remove (2) screws and rear panel (see figure 5). | Hot Tank |
|
6. | Pull drain tube out rear access opening. | Assembly |
|
|
| ||
7. | Remove plug from end of drain tube. |
|
|
| CAUTION: HOT WATER WILL IMIDIATLY FLOW |
|
|
| Cabinet | ||
| FROM DRAIN TUBE. | Assembly |
|
8.Remove ribbon cable for circuit board.
9.Let tank completely drain of water.
10.When finished draining tank, replace the drain tube plug.
11.Remove silicone tube from hot water faucet fitting.
12.Remove molded silicone tube from spray head top.
13.Remove (2) screws from rear switch plate (see figure 5).
14.Remove hot tank assembly from cabinet by lifting from the upper plastic reservoir (see figure 7).
Figure 7
Hot Tank / Cabinet Assembly