Oasis Concepts PHT1AQK Accessories Saddle Tapping Valve, SHUT-OFF Ball Valve Assembly

ACCESSORIES

SADDLE TAPPING VALVE

Part Number 400306

NOTE: State and local plumbing codes may prohibit the use of saddle tapping valves**. All connections must conform to applicable plumbing codes.

**All states prohibit the use of saddle tapping valves in commercial applications.

Do not install feed water assembly on the hot water line. Before installation, read the instructions on the outside of the packaging.

SHUT-OFF “BALL” VALVE ASSEMBLY

Part Number 031177-001 (3/8” tubing) 031177-002 (1/4” tubing)

It is recommended that all units have a shut-off valve installed directly behind the unit. This is a safety precaution in case the unit needs to be shut off for any reason. It will also help in the filter replacement and sanitation process.

IN-LINE AIR GAP ASSEMBLY (for RO units)

Part Number 030917-002

NOTE: All connections must conform to applicable plumbing codes.

The Air Gap assembly may be installed anywhere between the unit and the drain. It must be installed in a vertical position. The inlet quick connect fitting is for ¼” OD tubing and the outlet fitting connects to 3/8” OD tubing.

DRAIN CLAMP ASSEMBLY (for RO units)

Part Number 400307

The drain clamp assembly should be installed on a straight length of drainpipe between the “P” or “S” trap and the sink. If possible, orient the hole to be drilled toward the desired location of the drinking water faucet. Installation should be as far away as practical from the garbage disposal. If you have a double sink, install drain outlet on the sink drain opposite disposal.

1)Position drain outlet saddle on drainpipe. Allow adequate space for drilling operation.

2)Tighten saddle bolts evenly on both sides. Avoid over tightening.

3)Using the opening in the drain outlet saddle as a guide, drill ¼” hole in drain pipe.

4)Install stem adaptor fitting. Do not over tighten.

5)Push union elbow fitting onto stem adaptor fitting and connect drain tube.

DOW CORNING® COMPOUND 111

Part Number 030429-001

We recommend the use of DOW 111 exclusively to lubricate o-rings on all OASIS® components and systems. This silicone based FDA approved lubricant has high viscosity, does not readily evaporate at room temperature, and smoothly adheres to the o-ring. These qualities make DOW 111 an easy to use long lasting lubricant.