FUSER REPLACEMENT

The fuser is located inside the printer just behind the four image drum units.

WARNING!

If the printer has recently been powered on, some fuser components will be very hot. Handle the fuser with extreme care, holding it only by its handle, which will only be mildly warm to the touch. A warning label clearly indicates the area. If in doubt, switch the printer off and wait at least 10 minutes for the fuser to cool before opening the printer cover.

Switch off the printer and allow the fuser to cool for about 10 minutes before opening the cover.

1.Press the cover release and open the printer’s top cover fully.

2.Identify the fuser handle (1) on the top of the fuser unit.

1

C

2

M

Y

K

3.Pull the two fuser retaining levers (2) towards the front of the printer so that they are fully upright.

4.Holding the fuser by its handle (1), lift the fuser straight up and out of the printer. If the fuser is still warm, place it on a flat surface which will not be damaged by heat.

Replacing consumable items> 92