5.Remove the new fuser from its packaging and remove the transit material.

6.Holding the new fuser by its handle, make sure that it is the correct way round. The retaining levers (2) should be fully upright, and the two locating lugs (3) should be towards you.

3

2 2

7.Lower the fuser into the printer, locating the two lugs (3) into their slots in the metal partition which separates the fuser area from the image drums.

8.Push the two retaining levers (2) towards the rear of the printer to lock the fuser in place.

C

2

M

Y

K

Finally, close the top cover and press down firmly at both sides so that the cover latches closed.

Replacing consumable items> 93