
Install the O-ring.
Confirm that no foreign matter is attached, apply a thin coat of the accessory grease to the
How to Apply Grease to the O-ring
Make sure that your fingers and the Oring are free of dirt, and squeeze about 5 mm of lubricant onto a finger. (5 mm is the most appropriate amount.)
Surround the lubricant with three fingers and spread it over the ring. Be careful not to use excessive force as this may stretch the
After spreading the lubricant, check visually and by touch that the
Use the lubricant remaining on the fingers to clean and lubricate the case's contact surface.
CAUTION : • Always perform maintenance of the waterproof function even when the Case has been opened to exchange the battery or the image storage during shooting. Neglecting this maintenance may become the cause of water leakage.
•When the Case is not to be used for a long time, remove the
•When drying is done with salt attached, it is likely that a function impairment will be caused. After use, always wash off any salt.