8. Appendix

Q & A on the use of the PT-033

Q1 : What digital camera models can be used with this product?

A1 : This product (PT-033) is designed exclusively for use with the Stylus 720 SW and µ 720 SW digital cameras.

Q2 : What cautions must be observed when loading the digital camera into the Case?

A2 : Pay special attention to the following items when loading the camera into the Case.

(1)Make sure that the digital camera has enough battery power left. Battery power is used up very quickly underwater due to frequent flash use.

(2)Check the remaining number of pictures on the image storage. Please use a card with a sufficient remaining number in order to reduce the number of times the Case has to be opened and closed.

(3)Remove the strap from the digital camera.

When the camera is loaded without removing the strap, the strap may get caught when the Case is sealed and this will cause water leakage.

(4)After confirming that the digital camera is turned OFF, insert the camera gently into the Case.

(5)Before sealing the Case, confirm that the O-ring has been installed properly in the groove in the rear lid of the Case.

(6)Confirm that the O-ring and the O-ring contact surface on the front lid are free of dirt, hairs, and other foreign matter.

(7)Insert the silica gel for defogging. Please use silica gel for the Olympus Case.

Q3 : What cautions must be observed when using and storing the Case?A3 : Pay special attention to the following items.

(1)When the O-ring contact surface is pressed strongly from the outside of the Case, or when the Case is twisted, the waterproof function may be impaired and water leakage may be caused.

(2)When the Case is used, left or stored at the following locations, defective operation or trouble may be caused. Always avoid such locations.

(a)Places where the Case can reach high temperatures under direct sunlight or in a car, places with extremely low temperatures, and places with extreme temperature variations

(b)Places with open fire

E-34