Olympus 100 manual Printing the DATE/TIME, Quartzdate models only

18	CORRECTING THE DATE AND TIME
	(Quartzdate models only)

Be sure to correct the date and time after the batteries have been inserted or replaced.

1	1. Keep the MODE button pressed
	until the “year” indicator starts
	blinking.
	2. Press the SET button to adjust the
2	“year” indicator. If you press the
	button once, the number on the
	display will advance by 1. If you
	keep the button pressed, the
	numbers will run in rapid
	succession. If you pass the
	intended number, keep pressing to
	return to that number.
3	3. Press the MODE button once more
	to make the “month” indicator
	blink. Press the SET button to
	adjust the “month” indicator. As
	you press the MODE button, the
	blinking indicator changes in the
	order of “year”, “month”, “day”,
	“hour” and “minute”.
4	4. Repeat Steps 2 and 3 to set “hour”
	and “minute”. Make sure the
	“minute” indicator is blinking.

5	5. When “minute” has been set, press
	the MODE button. None of the
	indicators will be blinking and date/
	time correction is now complete.

PRINTING THE DATE/TIME	19
(Quartzdate models only)

First select the date/time mode you want to print.

Press the MODE button. As you press it, the mode will switch in the order shown below.

Keep the mode you want to print displayed.

None

Year-month-day

Month-day-year

Day-month-year

Day-hour-minute

•The date unit uses the same power source as the main unit.

•Be sure to correct the date and time after the batteries are replaced.

•The date/time is imprinted in the lower right corner of the picture.

•If the date/time is superimposed on a bright color like white, orange, yellow, etc., it may be difficult to read.

•The date/time may not be imprinted correctly on the frame(s) after the specified final exposure of the film.

•When black-and-white film is used, the date/time may not be printed.