Olympus 105 manual Care and Storage, First select the date/time mode you want to print, None

20	PRINTING THE DATE/TIME
	(Quartzdate models only)

First select the date/time mode you want to print.

None

Year-month-day

Month-day-year

Day-month-year

Day-hour-minute

Press the MODE button. As you press it, the mode will switch in the order shown below.

Keep the mode you want to print displayed.

•The date unit uses the same power source as the main unit.

•Be sure to correct the date and time after the batteries are replaced.

•The date/time is imprinted in the lower right corner of the picture.

•If the date/time is superimposed on a bright color like white, orange, yellow, etc., it may be difficult to read.

•The date/time may not be imprinted correctly on the frame(s) after the specified final exposure of the film.

•When black-and-white film is used, the date/time may not be printed.

CARE AND STORAGE 21

￿Do not leave the camera in any place exposed to excessive heat, humidity or direct sunlight — for example, in a car or on the beach.

￿Do not expose the camera to formalin or naphthalene.

￿If the camera gets wet, wipe it with a dry towel. The salt in seawater can be especially damaging.

￿Do not use organic solvents such as alcohol or paint thinner when cleaning the camera.

￿Do not leave the camera on or near a television, refrigerator or other appliance with a magnetic field.

￿Do not expose the camera to dust or sand as this could cause serious damage.

￿Do not shake the camera.

￿Do not apply excessive force to the zoom lens.

￿Do not expose the camera to extreme heat (over 40°C/104°F) or to extreme cold (below –10°C/14°F). Low temperatures, even within this range may sometimes cause deterioration in battery performance, temporarily disabling the camera.

￿Avoid leaving the camera unused for long periods of time. This can cause mold to grow on the camera as well as other problems. Try to press the shutter release button and check the operation of the camera before use.

￿Some airport X-ray machines can damage the film in your camera. Try to avoid passing your camera through these machines. Give it to the security officer for manual inspection.

￿Do not touch the front surface of the flash after using it continuously over a short period as the surface may be hot.