9

Appendix

Troubleshooting

Possible cause

Corrective action

Ref.

page

 

 

There is a problem with

See “Error codes”.

P. 107

the card.

 

 

The monitor is hard to see.

 

There is condensation*

Turn the camera off and wait until it dries

–

inside the camera.

before turning it on again.

 

The brightness of the

Use [s] to adjust monitor brightness.

P. 74

monitor is not adjusted

 

 

properly.

 

 

The monitor is exposed

Block the sunlight with your hand while taking

–

to direct sunlight.

pictures.

 

Vertical lines appear on

Aiming the camera at a bright subject in

–

the monitor screen

sunlight may cause vertical lines to appear

 

during shooting.

on the screen. This is not a malfunction.

 

The date recorded with the image data is wrong.

 

The date/time is not set.

Set the date/time. The clock adjustment is

P. 75

 

not factory-preset.

 

The camera has been

If the camera is left without batteries for 3

P. 75

left without batteries.

days, the date/time setting is canceled. Set

 

 

the date/time again.

 

The settings are returned to the factory default settings when the camera is turned off.

[ALL RESET] is set to [ON].

Set [ALL RESET] to [OFF].

P. 69

The picture is out of focus.

 

 

The subject was too

Move further away from the subject. To take

P. 40

close.

pictures closer than 20 cm (7.9") with the

 

 

zoom in the maximum wide position, use the

 

 

super macro mode.

 

Auto focus is not

Use the focus lock to focus on your subject.

P. 24

possible.

 

 

There is condensation*

Turn the camera off and wait until it dries

–

on the lens.

before turning it on again.

 

110