12 Shooting tips and maintenance

Shooting tips and information

Tips before you start taking pictures

The camera does not turn on even when a battery is loaded

The battery is not fully charged

• Charge the battery with the charger.

The battery is temporarily unable to function because of the cold

•Battery performance declines in low temperatures, and the charge may not be sufficient to turn on the camera. Remove the battery and warm it by putting it in your pocket for a while.

No picture is taken when the shutter button is pressed

The camera has turned off automatically

•To save battery power, if there is no operation, the camera goes into sleep mode after a fixed period of time and the camera stops operating. The camera activates again when you touch the shutter button or any other button. The camera will turn off automatically if there is no further operation for 4 hours. The camera will not work until it is turned back on. g“SLEEP” (P. 86)

The flash is charging

•When the flash is raised, the #symbol blinking in the super control panel or the viewfinder indicates that the flash is charging. Wait for the blinking to stop, then press the shutter button.

Unable to focus

•When the AF confirmation mark in the viewfinder is blinking, it indicates that the camera is unable to focus using AF. Press the shutter button again.

Noise reduction is activated

•When shooting night scenes, shutter speeds are slower and noise tends to appear in images. The camera activates the noise-reduction process after shooting at slow shutter speeds. During which, shooting is not allowed. You can set [NOISE REDUCT.] to [OFF].

g“Noise reduction” (P. 65)

The date and time has not been set

The camera is used with the settings at the time of purchase

•The date and time of the camera is not set when purchased. Set the date and time before using the camera. g“Setting the date/time” (P. 15)

The battery has been removed from the camera

•The date and time settings will be returned to the factory default settings if the camera is left without the battery for approximately 1 day. The settings will be canceled more quickly if the battery was only loaded in the camera for a short time before being removed. Before taking important pictures, check that the date and time settings are correct.

Shooting tips

Focusing on the subject

There are several ways to focus, depending on the subject.

AF target is not focused on the subject

•Use focus lock to focus the AF target on the subject. g“Focus lock kIf correct focus cannot be obtained” (P. 54)

Other things instead of the subject are in focus on the respective AF targets

• Set [AF AREA] to Rand focus on the center of the image. g“AF target selection” (P. 53)

maintenance and tips Shooting

12

103

EN