Manuals / Brands / Photography / Camera Accessories / Olympus / Photography / Camera Accessories

Olympus PT-15 Install the strap, Master the basic operation, Holding the Case

1 39

Download 39 pages, 510.57 Kb

Install the strap.

Install the strap on the Case body.

Installation explanation

Finished installation

Hand strap ring

Hand strap

CAUTION : Please install the strap correctly as shown above. Our company shall bear no responsibility for damage etc. caused by dropping the Case because of incorrect installation of the strap.

Master the basic operation.

Please master the basic operation of the Case before taking pictures.

Holding the Case

Hold the Case securely with both hands, keep your elbows close to your body, and hold the Case so that you can confirm the picture on the LCD monitor of the digital camera through the LCD monitor window of the Case.

Good example

Bad example

CAUTION : • Do not exert excessive force onto the lens window or the lens ring.

•Take care not to put your fingers etc. over the lens window and the flash diffuser.

Note: • Use the LCD monitor to confirm your picture. The optical viewfinder cannot be used.

E-11

Contents

Page Introduction Please read the following items before use For safe use Page Batteries For Prevention of Water Leakage Accidents Hair Fibers Grains of sand Handling the Product Page Contents 1.Preparations Advance Check of the Case Install the digital camera Taking Pictures Under Water 6.Maintaining the Waterproof Function・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・�E-26 Appendix 1. Preparations Check the contents of the package Names of the parts Install the strap Master the basic operation Holding the Case How to Press the Shutter How to Use the Mode Dial How to Use the Zoom Lever Setting the Zoom Lever 2. Advance Check of the Case Advance test before use Advance Test 3. Install the digital camera Check the digital camera Battery Confirmation Confirmation of the Remaining Number of Pictures to be Taken Remove the hand strap from the digital camera Open the case Pull up the mode dial of the protector Set the mode of the digital camera Load the digital camera Set the mode dial Insertion of silica gel Check the loading status Seal the Case Installation and Removal of the LCD Hood Installation Removal Perform the final checks Visual Inspection Final Test 4. Taking Pictures Under Water How to Use the Hand Strap Take pictures carefully Confirm the picture on the LCD monitor Quietly press the shutter lever 5. Handling After Shooting Wipe off any waterdrop Take out the digital camera Wash the Case with pure water Dry the Case 6. Maintaining the Waterproof Function Remove the O-ring Remove any sand, dirt, etc Install the O-ring How to Apply Grease to the O-ring Replace consumable products 7. Appendix Q & A on the use of the PT-015 Page Page Page Page After-saleService Specifications Page Page Technical Support (USA) European Technical Customer Support: