Olympus PT-15 Batteries

6.When using this product, install the O-ring for the front lid and the O-ring for the rear lid.

7.If the camera on the inside should become wet because of water leakage etc., immediately wipe off all moisture and confirm the operation.

8.Please remove the O-ring when traveling by air. Otherwise air pressure may make it impossible to open the Case.

9.For safe use of the digital camera in this product, please read the "Instruction Manual" for the digital camera carefully.

10.When sealing this product, take sufficient care that no foreign matter gets caught at the O-ring and the contact surfaces.

Batteries

●This protector uses the LCD monitor of the installed digital camera for shooting. Accordingly, the battery is exhausted faster than in case of shooting without use of the LCD monitor.

●Please use two lithium battery packs CR-V3 (our model LB-01). This is recommended because of its long life.

●When size AA batteries are used, alkaline batteries and Nicad batteries cannot exhibit their abilities at low temperatures. We recommend the use of Olympus Ni-H batteries. They are effective even when used at low temperatures, and as they can be used repeatedly, they are economical.

●Batteries are subject to self-discharging. Always use fresh batteries. Use a battery charger after recharging.

●Take care that the battery electrodes do not become wet. This may cause trouble or accidents.

●Carefully read the instruction manual for the camera about other cautions regarding batteries.

E-3

Contents

Page Introduction Please read the following items before use For safe use Page Batteries For Prevention of Water Leakage Accidents Hair Fibers Grains of sand Handling the Product Page Contents 1.Preparations Advance Check of the Case Install the digital camera Taking Pictures Under Water 6.Maintaining the Waterproof Function・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・�E-26 Appendix 1. Preparations Check the contents of the package Names of the parts Install the strap Master the basic operation Holding the Case How to Press the Shutter How to Use the Mode Dial How to Use the Zoom Lever Setting the Zoom Lever 2. Advance Check of the Case Advance test before use Advance Test 3. Install the digital camera Check the digital camera Battery Confirmation Confirmation of the Remaining Number of Pictures to be Taken Remove the hand strap from the digital camera Open the case Pull up the mode dial of the protector Set the mode of the digital camera Load the digital camera Set the mode dial Insertion of silica gel Check the loading status Seal the Case Installation and Removal of the LCD Hood Installation Removal Perform the final checks Visual Inspection Final Test 4. Taking Pictures Under Water How to Use the Hand Strap Take pictures carefully Confirm the picture on the LCD monitor Quietly press the shutter lever 5. Handling After Shooting Wipe off any waterdrop Take out the digital camera Wash the Case with pure water Dry the Case 6. Maintaining the Waterproof Function Remove the O-ring Remove any sand, dirt, etc Install the O-ring How to Apply Grease to the O-ring Replace consumable products 7. Appendix Q & A on the use of the PT-015 Page Page Page Page After-saleService Specifications Page Page Technical Support (USA) European Technical Customer Support: