Omega DP6-MLPS1 instruction sheet Installation Environment, Troubleshooting

INSTALLATION ENVIRONMENT

The unit should be installed in a location that does not exceed the maximum operating temperature and provides good air circulation. Placing the unit near devices that generate excessive heat should be avoided.

TROUBLESHOOTING

For further technical assistance, contact technical support at the appropriate company numbers listed.

Installation Procedure

The DP6-MLPS1 is shipped with all the necessary hardware to mount to the rear of an installed DP63000x. Refer to the instructions that correspond to your unit for proper installation.

The user must remove the common and V+ screw terminals on the rear of the DP63000x. Install the 3/16" hex drive stand-offs into the common and V+ terminals. The DP6-MLPS1 is then mounted to the stand-offs

using the supplied screws and square washers. AC power can then be connected to the terminal block of the DP6-MLPS1.