![](/images/new-backgrounds/1011110/1111011x1.webp)
OPERATING INSTRUCTIONS
PREPARATION FOR USE
WARNING: ALWAYS unplug the appliance prior to any type of maintenance on the unit. As all the appliances are thoroughly tested before sale, there may be some residual water in the boiler.
ASSEMBLY & OPERATION
To connect the tube and the accessories (fig. 1), insert part
(A)in part (B) turning this slightly to facilitate insertion. Make sure that key (C) is securely fastened in the hole provided (D). Open the reservoir cover (1) and pour in 6.3 cups
(1.5 liters) of tap water or distilled water if your tap water is particularly hard. Never add cleaning fluids. Close the reservoir cover (1). Before plugging in the appliance, make sure that you have assembled the tubes and accessories correctly and the steam switch on handgrip is “Off”. Press the on/off switch (2) to “On”; the steam ready light (3) will come on; when the light (3) switches off (after about 1 minute), you can start to use the appliance. To spray steam, simply press the steam switch button on the handle (6) (fig. 2).
When there is no more steam, fill the tank again. To avoid damage, never use the steam gun without water. If the tank is full and no steam is sprayed, have the appliance checked by the manufacturer. Always switch off the appliance after use, pull out the plug and drain any residual water from water tank.
Important User Information
Please note that this steam cleaner has a “flow through injection” type boiler and is not a pressurized system. It will take approximately
NOZZLE CLEANING INSTRUCTIONS
Your steamer should not normally require cleaning, however, should you notice a marked decrease in steam output it may be necessary to remove mineral deposit
If tank is empty, fill with water, (we recommend using purified or mineral water), then
output is normal. If steam output is still low, follow these cleaning instructions:
1.Unplug steam cleaner from wall outlet.
2.Use a small diameter stiff metal wire such as a straightened metal paperclip and carefully insert the end of the wire into the nozzle orifice.
3.Move wire back and forth several times to remove any deposits.
4.Reconnect appliance to power outlet, switch on and note steam output.
5.If steam performance does not improve, repeat steps #1 through #4.
5
OPERATING INSTRUCTIONS cont.
ON/OFF STEAM SWITCH
1.Before turning the steam switch to the “On” position, wait until the “Steam Ready” light(Red) located on the unit has turned off.
2.Setting this switch to the “On” position will start the flow of steam.
CAUTION:
Upon initial use, the steam will be mixed with water, hot enough to scald. Ensure that the floor brush is resting on the floor or the hose handgrip is directed away from user when steam switch is turned on. Never direct the nozzle or brush end of the unit toward yourself or anyone near you.
CAUTION:
The “On/Off Steam Switch” located on the handle must be in the “Off” position before attaching or disassembling accessories.
Never leave the “Steam Switch” in the “On” position when unit is not in use.
Glass & Tile Squeegee
This attachment is very useful for cleaning large windows, plastic material, ceramic, tiled surfaces, marble planes, etc.
Apply steam abundantly, rub with the spongy side of squeegee and remove with the glass wiping rubber located at the front edge of squeegee.
Detail Cleaning Attachment
This attachment is very useful for cleaning surfaces that are difficult to reach. It is ideal for radiators, door and window jambs, shutters and sanitary fixtures. The following parts can be applied to this attachment:
6