Omega OMG-USB-SER-2 manual Operating System Installation

Installation

Installation

Operating System Installation

Choose Install Software at the beginning of the CD and install SeaCOM.

System Installation

The screen captures below are taken from a Windows 98 installation. Your particular operating system may differ slightly from what is shown based on your version of Windows.

The OMG-USB-SER-2can be connected to any upstream type “A” port either at the PC host or an upstream hub. The OMG-USB-SER-2is hot pluggable, meaning there is no need to power down your computer prior to installation.

Connect the OMG-USB-SER-2to an upstream host or hub.

The New Hardware Found wizard will now proceed to locate the appropriate drivers. These drivers were installed during the SeaCOM software setup procedure. Once the drivers are found a new window will pop up indicating the installation of each of the four new ports.

If you view the system’s Device Manager, you should have new “COM” ports in the Ports (COM & LPT) Device Class. This is shown on the following page.

OMG-USB-SER-2 Page 2