SETUP MODE
Setup is used for configuring various parameters of DPS3301 unit.
These parameters include entering limits, timers,
Entering and Exiting Setup Mode:
To get into setup mode, press and hold SETUP key. The display will show ELPSd t and then the value of elapsed time. Keep
To return from SETUP to normal display/run mode, simply push and hold down the ‘RESET’ key. On exiting, the display will briefly show 'SAVING' to indicate that the new data is being saved in nonvolatile memory (key should be held in until the word ‘SAVING’ shows up on the display). Setup mode is also exited automatically if no key action is detected for about 5 minutes. On automatic exit, all the changes made up to that point are saved in the permanent memory.
How To Increase/Decrease Programmable Values in
Setup
Once a parameter is displayed (e.g. 01234), the ‘^DIG v’ key can then be used for increasing or decreasing the value of the flashing digit. For incrementing, push and hold in ‘^DIG v’ key. To decrement, release ‘^DIG v’ key and immediately push it (and hold in) again. To move on
to the next digit, push ‘<DIG>’ key till the desired digit starts flashing. Again, use ‘^DIG v’ key to change its value.
Passcode Entry:
Passcode entry is a four digit number which keeps unauthorized personnel from changing the unit’s parameters. Front panel keys are each marked with a small digit in the lower right corner. For the five keys there are five digits
As soon as correct four digit
1. PrG | Ctr (for 'Program Controller’) 2. PrOG Lt (for 'Program |
|
Limits') |
| |
The unit starts with 'Program Controller’ as the active mode (displaying | ‘PROGRAM CONTROLLER’ MODE | |
PrG | Ctr). To select alternate mode, push ‘^DIG v’ key. Once the |
|
desired mode is displayed, push ‘SETUP’ key to select it. Page 9
