5.0REVIEWING THE FRONT BUTTONS AND DISPLAY
| BUTTON | DISPLAY MODE OPERATION | ENTERING PROGRAM MODE | PROGRAMMING MODE OPERATION |
| SEL | Index display through enabled values | Press and hold for 2 seconds to activate | Store selected parameter and index to next parameter |
| RST | Resets values (MIN/MAX) or outputs |
| Advances through the program menu |
|
| Increments selected parameter value or selection | ||
|
|
|
| |
|
|
|
| |
| OPERATING MODE DISPLAY DESIGNATORS | “1” - To the right of the display indicates setpoint 1 output activated. | |||
MAX - Maximum display capture value | ||||
MIN - Minimum display capture value | “2” - To the right of the display indicates setpoint 2 output activated. | |||
Pressing the SEL button toggles the meter through the selected displays. If display scroll is enabled, the display will toggle automatically every four seconds between the enabled display values.
6.0PROGRAMMING THE METER
OVERVIEWPROGRAMMING MENUIt is recommended all programming changes be made off line, or before installation. The meter normally operates in the Display Mode. No parameters can be programmed in this mode. The Programming Mode is entered by pressing and holding the SEL button. If it is not accessible then it is locked by either a security code, or a hardware lock.
MODULE ENTRY (SEL & RST BUTTONS)The Programming Menu is organized into separate modules. These modules group together parameters that are related in function. The display will alternate between Pro and the present module. The RST button is used to select the desired module. The displayed module is entered by pressing the SEL button.
MODULE MENU (SEL BUTTON)Each module has a separate module menu (which is shown at the start of each module discussion). The SEL button is pressed to advance to a particular parameter to be changed, without changing the programming of preceding parameters. After completing a module, the display will return to Pro NO. Programming may continue by accessing additional modules.
SELECTION / VALUE ENTRYFor each parameter, the display alternates between the present parameter and the selections/value for that parameter. The RST button is used to move through the selections/values for that parameter. Pressing the SEL button, stores and activates the displayed selection/value. This also advances the meter to the next parameter.
For numeric values, press the RST button to access the value. The right hand most digit will begin to flash. Pressing the RST button again increments the digit by one or the user can hold the RST button and the digit will automatically scroll. The SEL button will advance to the next digit. Pressing and holding the SEL button will enter the value and move to the next parameter.
The Programming Mode is exited by pressing the SEL button with Pro NO displayed. This will commit any stored parameter changes to memory and return the meter to the Display Mode. (If power loss occurs before returning to the Display Mode, verify recent parameter changes.)
PROGRAMMING TIPSIt is recommended to start with Module 1 and proceed through each module in sequence. When programming is complete, it is recommended to record the parameter programming and lock out parameter programming with the user input or programming security code.
FACTORY SETTINGSFactory Settings may be completely restored in Module 2. This is useful when encountering programming problems.
ALTERNATING SELECTION DISPLAYIn the explanation of the modules, the following dual display with arrows will appear. This is used to illustrate the display alternating between the parameter on top and the parameter’s Factory Setting on the bottom. In most cases, selections and values for the parameter will be listed on the right.
Indicates Program Mode Alternating Display
Parameter USrIN «
ªN0 Selection/Value
Factory Settings are shown.
8