Omega Vehicle Security DP63000A-I MODULE 5 - S, 6.5MODULE 5 - SERIAL SETUP PARAMETERS (5-SEr), Stb-n, rEn-n, YES, OUTPUT RESET WITH DISPLAY RESET, STANDBY OPERATION, L-dLY

button or user input manual reset, serial reset command or meter power cycle. When the user input or RST button is activated (momentary action), the corresponding “on” output is reset immediately and remains off until the trigger point is crossed again. (Previously latched alarms will be off if power up Display Value is lower than setpoint value.)

L-dLY= Latch with delay reset action; This action latches the output on at the trigger point per the Setpoint Action shown in Setpoint Output Figures. Latch means that the output can only be turned off by the front panel RST button or user input manual reset, serial reset command or meter power cycle. When the user input or RST button is activated (momentary action), the meter delays the event until the corresponding “on” output crosses the trigger off point. (Previously latched outputs are off if power up Display Value is lower than setpoint value. During a power cycle, the meter erases a previous L-dLYreset if it is not activated at power up.)

OUTPUT RESET WITH DISPLAY RESET

rEn-n		«
			NO	YES
ª
	YES

This parameter enables the RST button or user input to reset the output when the display is reset.

Note: For this parameter to operate, the RST button or User Input being used must be set to dSP and the Input value must be displayed. If these conditions are not met, the output will not reset.

STANDBY OPERATION

Stb-n	«
		NO	YES
ª	NO

When YES, the output is disabled (after a power up) until the trigger point is crossed. Once the output is on, the output operates normally per the Setpoint Action and Output Reset Action.

CHANGE DISPLAY COLOR w/OUTPUT STATE

ChC-n	«
		NO	YES
ª
	NO

This parameter enables the backlight DP63000B-I to switch the backlight color

Setpoint Output Reset Actionswhen the output state changes. This parameter is only active for the backlight version.

6.5MODULE 5 - SERIAL SETUP PARAMETERS (5-SEr)

PARAMETER MENU

The Serial Setup Parameters are only active when the optional RS232 or RS485 serial communications module is installed in the meter. Refer to the DP6-COM bulletin for complete details on DP63000 serial communications.

13