Omega Vehicle Security DP63000A-I GENERAL METER SPECIFICATIONS, PART NUMBER INFORMATION, OLOL, POWER, MEMORY, Torque, SAFETY, WEIGHT, DISPLAY, Altitude, Wire Gage, DP63000A-I, DP63000B-I, Surge

GENERAL METER SPECIFICATIONS

1. DISPLAY: 5 digit LCD 0.48" (12.2 mm) high digits DP63000A-I: Reflective LCD with full viewing angle

DP63000B-I: Transmissive LCD with selectable red or green LED backlight, viewing angle optimized. Display color change capability with output state when using an output module.

2. POWER: Input voltage range is +9 to +28 VDC with short circuit and input polarity protection. Must use a DP6-MLPS1 or a Class 2 or SELV rated power supply.

MODEL	DISPLAY COLOR	INPUT CURRENT	INPUT CURRENT
		@ 9 VDC WITHOUT	@ 9 VDC WITH
NO.
		DP6-RLY0	DP6-RLY0
DP63000A-I	---	10 mA	40 mA
DP63000B-I	Red (max intensity)	85 mA	115 mA
DP63000B-I	Green (max intensity)	95 mA	125 mA

3. INPUT RANGES: Jumper Selectable

D.C. Currents: 200 ∝A, 2 mA, 20 mA, or 200 mA

4. SIGNAL INPUTS:

INPUT	ACCURACY	INPUT	MAX		TEMP.
	@23 °C, less		INPUT	RESOLUTION
RANGE		IMPEDANCE			COEFFICIENT
	than 85% RH		SIGNAL
200 ∝A	0.1% of span	1.111 KΩ	15 mA	10 nA	70 ppm / °C
2 mA	0.1% of span	111 Ω	50 mA	.1 µA	70 ppm / °C
20 mA	0.1% of span	11 Ω	150 mA	1 µA	70 ppm / °C
200 mA	0.1% of span	1 Ω	500 mA	10 µA	70 ppm / °C

5.OVERRANGE RATINGS, PROTECTION & INDICATION:

9 to 28 VDC power circuit is not isolated from the signal circuit. Input Overrange Indication: “OLOL”.

Input Underrange Indication: “ULUL”.Display Overrange/Underrange Indication: “.....”/“-.....”6.DISPLAY RESPONSE TIME: 500 msec min.7.NORMAL MODE REJECTION: 60 dB 50/60 Hz

8.USER INPUT (USR): Programmable input. Connect terminal to common (USR COMM) to activate function. Internal 10KΩ pull-up resistor to +9 to 28 VDC.

Threshold Levels: VIL = 1.0 V max; VIH = 2.4 V min; VMAX = 28 VDC

Response Time: 5 msec typ.; 50 msec debounce (activation and release)

9.MEMORY: Nonvolatile E2PROM memory retains all programming parameters and max/min values when power is removed.

10. ENVIRONMENTAL CONDITIONS:Operating Temperature Range for DP63000A-I:-35 to 75°C

Operating Temperature Range for DP63000B-I depends on display color and intensity level as per below:

	INTENSITY LEVEL	TEMPERATURE
Red Display	1 & 2	-35 to 75°C
	3	-35 to 70°C
	4	-35 to 60°C
	5	-35 to 50°C
Green Display	1 & 2	-35 to 75°C
	3	-35 to 65°C
	4	-35 to 50°C
	5	-35 to 35°C

Storage Temperature: -35 to 85°C

Operating and Storage Humidity: 0 to 85% max. relative humidity (non- condensing)

Vibration According to IEC 68-2-6: 5 to 500 Hz, in X, Y, Z direction for 1.5 hours, 5 g’s.

Shock According to IEC 68-2-27: Operational 30 g, 11 msec in 3 directions

Altitude: Up to 2000 meters

11.CONNECTIONS: Wire clamping screw terminals Wire Strip Length: 0.3" (7.5 mm)

Wire Gage: 30-14 AWG copper wire

Torque: 5 inch-lbs (0.565 N-m) max.

12.CONSTRUCTION: This unit is rated for NEMA 4X/IP65 requirements for indoor use. Installation Category I, Pollution Degree 2. High impact plastic case with clear viewing window. Panel gasket and mounting clip included.

13.CERTIFICATIONS AND COMPLIANCES:SAFETY

UL Recognized Component, File #E313607, UL61010A-1, CSA22.2 No. 61010-1 Recognized to U.S. and Canadian requirements under the Component Recognition Program of Underwriters Laboratories, Inc.

UL Listed, File # E313547, UL508, CSA C22.2 No. 14-M95 LISTED by Und. Lab. Inc. to U.S. and Canadian safety standards

IEC 61010-1, EN 61010-1: Safety requirements for electrical equipment for measurement, control, and laboratory use, Part 1.

IP65 Enclosure rating (Face only), IEC 529

Type 4X Indoor Enclosure rating (Face only), UL50

ELECTROMAGNETIC COMPATIBILITY

Emissions and Immunity to EN 61326: Electrical Equipment for Measurement, Control and Laboratory use.

Immunity to Industrial Locations:
Electrostatic discharge	EN 61000-4-2	Criterion A
		4 kV contact discharge
		8 kV air discharge
Electromagnetic RF fields	EN 61000-4-3	Criterion A
		10 V/m
Fast transients (burst)	EN 61000-4-4	Criterion A
		2 kV power
		1 kV signal
Surge	EN 61000-4-5	Criterion A
		1 kV L-L,
		2 kV L&N-E power
RF conducted interference	EN 61000-4-6	Criterion A
		3 V/rms
Power frequency magnetic fields EN 61000-4-8		Criterion A
Emissions:		30 A/m
Emissions	EN 55011	Class A

Notes:

1.Criterion A: Normal operation within specified limits.

14.WEIGHT: 3.2 oz (100 g)

PART NUMBER INFORMATION

DESCRIPTION	PART NUMBER
DC Current Meter with reflective display	DP63000A-I
DC Current Meter with backlight display	DP63000B-I
Single Relay Output Card	DP6-RLY0
Dual Sinking Open Collector Output card	DP6-SNK0
RS485 Serial Communications Card	DP6-COM1
RS232 Serial Communications Card	DP6-COM2
Micro-Line Power Supply, 85 to 250 VAC	DP6-MLPS1
RS232 Programming Cable (DB9-RJ11)	DP6-232-CABLE
RS485 Programming Cable (DB9-RJ11)	DP6-485-CABLE
PC Configuration Software for Windows 98, ME, 2000, XP *	DP6-SOFT

4