USING THE
held down for approximately 10 seconds to dissipate any battery surface charge and give the most consistent reading. Best SOC readings are given with both power supplies off and no charging current. If the supplies are delivering current to an external load, the SOC will indicate slightly lower than actual. If charging current is flowing into the batteries, the SOC will indicate slightly higher than actual.
MISCELLANEOUS
CONTROL INPUT...SPECIAL APPLICATIONS
The CONTROL INPUT circuit is schematically shown in Figure 3. The signal is optically isolated from the
This allows for nominal 0 and 5 VDC operation as provided from the
For special applications, it may be desired to bypass the
1.TURN THE
2.Remove the
3.Remove the three thumbscrews at the top of the
4.Slowly, tug on the front panel handle (located near the top of the front panel) and the front panel will swing open on its hinge.
If this RED jumper is moved to the EXTERNAL position, current limiting MUST BE PROVIDED to limit the current flowing through the
Shorting Jumper
Resistor limits current through
8.2K Ohm Resistor | |
Signal Input |
|
Control Input Equivalent Circuit
Shorting Jumper
Shorting Jumper position for internal current limit (this is the factory default setting)
Position for NO internal current limiting
3 gold pins on circuit board
View of |
Figure 4
Omega Engineering Inc. | 6 | Stamford, CT |
