Omnimount installation instructions Models PMD.5 - PMD1 - PMD2, Step, Description, ware

Models: PMD.5 — PMD1 — PMD2

Step 5

Slide the bottom projector mounting plate onto the previously installed top projector mounting plate. (Fig. 11)

Note: Make sure that the cables don’t get pinched while sliding the plates together.

Fig. 11

Fig. 12

Important: Always secure projector plates by installing 3/8” screws (G) into holes on front edge of plates.

Additional security can be provided by installing small pad- locks through security slots at the rear of the projector plates. (Fig. 12)

Attach cables to the projector. Turn projector ON, and make pitch and keystone adjustments as per the projector manufacturers instructions. For additional pitch/tilt, use the three adjustment knobs on top of the PMD mount (Fig. 13).

Fig. 13

	Part	Description	Qty.
		Mount Assembly Hard-
		ware
	A	Top Projector Plate	1
	B	Bottom Projector Plate	1
	C	Pipe Drop Assembly	1
	D	Plastic Cover	1
	E	Ceiling Plate	1	Bag
	F	Hex Screw: ¼”-20 X ¼”	1	(d)
	G	Screw: ¼”-20 X 3/8”	2	(c)
	H	Hex Screw: ¼”-X 5/8”	4	(d)
	I	Hex Screw: ¼”-X ½”	6	(d)
	J	Lag Bolt: 5/16” X 3”	4	(e)
	K	Plastic Plugs	14	(b)
2		Hex Wrench	1	(d)	7