4. Taking a Measurement

Measurement should be taken on a level and hard surface.

 

 

 

 

1. Turn on the power.

4. Start measurement.

“CAL” blinks on the display, then the display changes to “0.0 kg”.

*If you step onto the unit before “0.0 kg” appears on the display, an error message “Err” will appear.

2.When the “0.0 kg” is displayed, take out the display unit.

1)Step on the main unit and place your feet on the foot electrodes with your weight evenly distributed.

The display will show your weight and then the weight result will blink twice.

The unit will then start to measure your body fat percentage, visceral fat level and skeletal muscle percentage.

Note: Do not take out the display unit until “0.0 kg” appears on the display. Otherwise, the weight of the display is add to your body weight which causes an incorrect result.

3.Select the personal profile number.

Press the USER button while holding the display unit. Selected number will appear after blinking once.

If the following display is indicated:

Your personal data is not stored in the personal profile number you have selected. Please see Section 3 to store personal data.

2)When “START” appears on the display, extend your arms straight at a 90° angle to your body.

The indicators in the measurement progress bar at the bottom of the display will gradually appear, from left to right.

3)After the measurement

is complete, your weight is displayed again. At this point you may step off the unit.

If you do not have personal data stored on the unit (GUEST mode):

1)Press the GUEST button while holding the display unit.

2)The GUEST indication “G” appears on the display.

3)Set the personal data (age, gender, and height). Read steps 3 through 4 in Section 3, Setting and Storing Personal Data.

EN

7

Page 8
Image 8
Omron BF510 Taking a Measurement, Turn on the power Start measurement, Select the personal profile number