One for All Little Easy manual Trouble-Shooting, ONE for ALL Code section?

■ ■ ■ ■

Trouble-Shooting

Red light does not blink	Replace batteries with 2 fresh, new
when you press a key?	AAA/LRO3 alkaline batteries.
The ONE FOR ALL	Make sure you are using new
does not respond after	batteries and are aiming the
pressing a key?	ONE FOR ALL at your device.
The ONE FOR ALL does	A) Try all the codes listed for your brand
not operate your	B) Try the search method on page 10.
device(s)?
Your brand is not listed	Try the search method on page 10.
in the ONE FOR ALL
code section?
When following the set-	Did you use the Code Lock feature?
up instructions, the red	You must first unlock the code before
light on the ONE FOR ALL	entering a new code. Follow the
only blinks once instead	instructions on page 19 to do this.
of twice after you enter a
three-digit code?
The ONE FOR ALL	You may be using the wrong code.
is not preforming	Start the search method over
commands properly?	again to locate the proper code.
Press a key but get the	Hold MAGIC until the red light blinks
wrong result?	twice, then press 992 and the device key
	twice. You will need to set-up your
	device again. Try the codes for brand
	or the search method on page 10.
You cannot control the	Hold MAGIC until red light blinks twice
volume feature of your	Then press 993 and VOL+. To set the
Satellite, Cable Con-	volume control back to TV (Punch-
verter or TV/Video	Through), hold Magic until the red
combination OR	light blinks twice, then press 993 TV.
you cannot control the
volume of the TV set
up on the AUX key?
Problems changing	Enter the programme number exactly
channels?	as you would on your original remote.
Video not recording?	As a safety feature on your ONE FOR
	ALL, you must press the Record key
	twice .
Scan does not work on	Make sure your original remote had a
your device?	programme +/- key.

■ ■ ■ ■

20