Device Sleeptimer
If your television has a "Sleeptimer" function built in, you can access this function with your ONE FOR ALL remote. To do so:
1Make sure your television is switched on (not in standby).
2Point the ONE FOR ALL at your television and press and release MAGIC then press POWER. You should see the Sleeptimer activate on your TV screen.
To increase the timer, simply press POWER again (within 5 seconds) until the timer gets to the desired time.
To deactivate the Sleeptimer, repeat steps 1 and 2 above. During step 3, continue pressing POWER (within 5 seconds) until the timer indicates zero minutes.
Important note: Depending on how you used the sleeptimer function on your original remote, you might need to access the sleeptimer of your televi- sion in a different way (through menu for example).
ONE FOR ALL Sleeptimer
If your device does not have a sleeptimer function
Installing the ONE FOR ALL Sleeptimer:
1Press and hold MAGIC until the red light blinks twice.
2Press 9 7 0. The red light will blink twice again.
Now your ONE FOR ALL 1 is setup to use the ONE FOR ALL Sleeptimer on the device you selected in the setup above.
To activate the ONE FOR ALL Sleeptimer:
It is possible to set the ONE FOR ALL Sleeptimer for 15, 30, 45 or 60 minu- tes. To do this, first make sure your TV is switched on.
3Press and release the MAGIC key and then press POWER. The red light will blink once to indicate the timer is activated for 15 minutes.
4To increase the timer, simply press the POWER key again (this must be done within 5 seconds). The red light will blink twice indicating the timer is set for 30 minutes (2x15).
5You can press the POWER to a maximum of four times. This will set the timer to 60 minutes (indicated by 4 blinks).
Once you have set the timer to the desired time, set your ONE FOR ALL remote down, pointing it at your device. When the programmed amount of time has elapsed, the ONE FOR ALL 1 will send the command for POWER, thereby turning off your device.
Important notes:
-The red light on the ONE FOR ALL 1 will blink every 15 seconds indicating that the remote is in sleeptimer mode.
-To deactivate the timer, simply press any key on the ONE FOR ALL 1 remote.
-Once the ONE FOR ALL Sleeptimer has been installed it is not necessary to repeat steps 1 and 2 above every time you wish to activate the timer. Simply repeat steps
-To uninstall the ONE FOR ALL Sleeptimer back to device sleeptimer, repeat steps 1 and 2 above and the red light will blink four times.
-Remember to place the remote so it is pointing to your device when the timer is activated.
10 | WWW.ONEFORALL.COM |
