One for All URC-7010 manual ONE for ALL Recall Previous Channel, Trouble-Shooting

ONE FOR ALL Recall (Previous Channel)

If your television has a Recall or Previous / Last Channel function, the Recall key allows you to access this function. If, however, your television does not have a Recall or Previous / Last Channel function, then you can set up your own two favourite channels with the ONE FOR ALL Recall function.

The ONE FOR ALL Recall function allows you to program up to two channels, each consisting of a maximum of 4 key presses per channel entry. This allows you to swap back and forth between two channels with the press of a single key.

1Press the MAGIC and RECALL keys simultaneously, until the red light blinks twice.

2Enter the first channel number exactly as you would on your original remote (e.g. <-/-->, <1>, <2> to get channel number 12).

3Press RECALL once and release.

4Enter the second channel number exactly as you would on your original remote (e.g. <-/-->, <2>, <3> to get channel number 23).

5Press the MAGIC key, and the red light blinks twice.

Now, if you press RECALL, you will obtain the second channel programmed (being <23>) and if you press RECALL again you will obtain the first chan- nel programmed (being <12> in our example).

Important notes:

-To enter only one channel number, skip steps 3 & 4.

-If two channel numbers have been stored previously, entering one new channel will delete the oldest entry.

To reset the RECALL key:

1Press MAGIC and RECALL simultaneously until the red light blinks twice.

2Press RECALL and release.

3Press MAGIC and release and the red light will blink twice.

Trouble-Shooting

Problem:	Solution:
Your brand is not listed in the	Try the search method on page 7.
code section?
The ONE FOR ALL does not	A) Try all the codes listed for your
operate your device(s)?	brand.
	B) Try the search method on page 7.
The ONE FOR ALL is not	You may be using the wrong code. Try
performing commands	repeating the Direct Set-Up using
properly?	another code listed under your brand
	or start the search method over again
	to locate the proper code.
Problems changing channels?	Enter the programme number exactly
	as you would on your original remote.
The ONE FOR ALL does not	Make sure you are using new batteries
respond after pressing a key?	and are aiming the ONE FOR ALL at
	your television.
The red light does not blink	Replace batteries with 2 fresh, new
when you press a key?	“AA/LR6” alkaline batteries.

WWW.ONEFORALL.COM 11