USING CHANNEL SCAN
In the AUX,CBL/SAT,or TVmode, use the FAV
key to start a 3-second scan ofall channels.
Ifprogrammed, use the FAV key to scan only
your favorite channels to view a desired channel
(see Programming Favorite Channel Scanbelow).
1. IfFavorite Channel Scan has been set up,skip
to step 2.Otherwise,press AUX,CBL/SAT,or TV
once.The two bottom IRseg ments flash once.
2. Press FAVonce. The IR segments will
display outgoing animation as each channel
is changed.
•IfFavorite Channel Scan has been set up,
scanning offavorite channels will start
and cycle through stored channels for
3minutes or until stopped by pressing
any key.
•IfFavorite Channel Scan has not been set
up,scanning will start with the current
channel,then proceed to the next channel
up and cycle through all channels for
3minutes or until stopped by pressing
any key.
3. To stop scanning channels at any time,press
any key once.
PROGRAMMING FAVORITE CHANNEL SCAN
In the AUX,CBL/SAT,or TVmode,you can store
a list ofup to 10 favorite channels,in any order,
that will be immediately scanned when FAVis
pressed (see Using Chan nel S can above).
NOTE:Favorite channels can only be programmed
for one mode.After programming,if FAV is pressed
while in another mode,the remote control will start a
normal channel scan instead (if applicable to the
selected device).
1. Press and hold SETUPuntil the two bottom
IRsegments flash twice. The Program Keys
will appear (as shown above right) and SETUP
flashes repeatedly.
2. Select a Favorite Channel Modeby pressing
AUX,CBL/SAT,or TVonce.The two bottom IR
segments flash once as the selected device
key animates.
3. Press OTHERonce.T he Other programming
screen will appear:
4. Using the Number Keys,enter 9 9 6.The two
bottom IRsegments will flash twice and
display the Favorite Channe l programming
screen.
NOTE:Ifthe the two bottom IR segments display
one long flash,an error has occurred.Try repeating
this step.
5. Using the Number Keys,enter a favorite
channel number (e.g.,0 1 2). Then press
SETUPonce.The two bottom IR segments will
flash three times confirming your entry.
NOTE:Ifthe original remote control required
pressing an Enter key to change the channel,also
press the ENTERkey after the channel number
(e.g.,0 1 2 ENTER).
6. Ifdesired, repeat step 5 for each channel to be
stored,up to a total of 10 channels.
NOTE:After storing 10 channels,the remote control
will exit the Favorite Channel programming screen
and again display the Program Keys.
KAMELEON 8-DEVICE REMOTE

22 Using Channel Scan/Programming Favorite Channel Scan

OFA Kameleon UG 5/8/03 3:23 PM Page 22