Rear Panel, 6 7 8 9 J K L M, Introduction-Continued

Introduction—Continued

Rear Panel

1	2	3	4	5
6 7 8 9 J K L M			N

* The type and number of connectors depends on the destination country.

AGND terminal

Terminal for connecting a turntable’s ground wire.

BSPEAKERS A

Terminal posts for connecting speaker set A.

CSPEAKERS B

Terminal posts for connecting speaker set B.

DAC INLET

Supplied power cord connects here.

EAC OUTLETS

Supply AC power to other audio components. The type of connector depends on the destination coun- try.

FPHONO (MM)

Analog audio input for connecting a turntable with a moving-magnet cartridge.

GCD

Analog audio input for connecting a CD player.

HTUNER

Analog audio input is for connecting a tuner.

ITAPE IN/OUT

Analog audio input and output for connecting a cas- sette deck.

JLINE

Analog audio input for connecting a component with a line-level audio output (e.g., game console, TV, etc.)

KDOCK

Analog audio input for connecting an RI Dock.

LPREOUT

Analog audio output for connecting a separate power ampliﬁer.

Note:

•Do not connect a source component to the PRE- OUT jacks.

M REMOTE CONTROL

(Remote Interactive) jacks can be connected to

jacks on other Onkyo audio components so that you can control them with the A-9377’s remote con-

troller. To use , you must also make an analog audio connection between the A-9377 and each component.

NVOLTAGE SELECTOR (not European model)

If your A-9377 has a VOLTAGE selector, set it to match the AC voltage used in your area before plug- ging in the power cord. (See page 3.)

See pages 11–14 for connection information.