Onkyo CR-515 CR-315 instruction manual Before Using the CD Receiver, Installing the Batteries

Before Using the CD Receiver

Installing the Batteries

1 Detach the battery cover by pressing the tab and pulling up the cover.

2 Insert two AA-size batteries into the bat- tery compartment.

Carefully follow the polarity diagram (positive

(+)and negative (–) symbols) inside the battery compartment.

3 After the batteries are installed and seated correctly, attach the compartment cover.

Using the Remote Controller

When you operate the remote controller, point it at the CD receiver’s remote control sensor, as shown below.

Remote control sensor

m .5 Approx.) ft (16

CD receiver

Notes:

•The remote controller may not work reliably if the CD receiver is subjected to bright light, such as direct sun- light or inverter-type fluorescent lights. Keep this in mind when installing.

•If another remote controller of the same type is used in the same room, or the CD receiver is installed close to equipment that uses infrared rays, the remote control- ler may not work reliably.

•Don’t put anything, such as a book, on the remote con- troller because the buttons may be pressed inadvert- ently, thereby draining the batteries.

•The remote controller may not work reliably if the CD receiver is installed in a rack behind colored glass doors. Keep this in mind when installing.

•The remote controller will not work if there’s an obsta- cle between it and the CD receiver’s remote control

sensor.

Notes:

•If the remote controller doesn’t work reliably, try replacing the batteries.

•Don’t mix new and old batteries or different types of batteries.

•If you intend not to use the remote controller for a long time, remove the batteries to prevent damage from leakage or corrosion.

•Expired batteries should be removed as soon as possi- ble to prevent damage from leakage or corrosion.

5