Using Your iPod/iPhone model’s Alarm Clock

You can use your iPod/iPhone model’s Alarm Clock function to automatically turn on your iPod/iPhone and amp at a specified time. Your amp’s input source will automatically be set to the input to which your iPod/iPhone is con- nected.

Notes:

This function only works when the OSD mode is set to Off.

To use this function, your iPod/iPhone must be in the RI Dock, and the RI Dock must be connected to your amp with both an cable and an audio cable.

When you use this function, be sure to set your amp’s volume control to a suitable level.

Your amp may take several seconds to startup, so you might not hear the first few seconds of the first song/video.

Charging Your iPod/iPhone model’s Bat- tery

The RI Dock charges your iPod/iPhone model’s battery while your iPod/iPhone is in the RI Dock.

Notes:

To charge your iPod/iPhone battery, the AC adapter must be plugged into a suit- able wall outlet and connected to the RI Dock’s DC IN jack.

See your iPod/iPhone model’s instruction manual for more information on battery charging.

Setting the Remote Controller’s ID

If you cannot adjust the volume of your Onkyo component with the DS-A4’s remote controller, try changing its remote control ID. The default setting is #1.

Some Onkyo components are set to ID #2 or #3.

While pressing and holding down the [SETUP] button, press one of the following buttons for more than 3 seconds to set the ID:

ID #1: PLAYLIST Up [ ] button

ID #2: ALBUM Up [ ] button

ID #3: PLAYLIST Down [

] button

ID #4: ALBUM Down [

] button

13

Page 13
Image 13
Onkyo DS-A4 instruction manual Setting the Remote Controller’s ID, Using Your iPod/iPhone model’s Alarm Clock, Button