Connecting the z cables

ED-205

 

MASTER VOLUME

EFFECT

MODE

STANDBY/ON

 

STANDBY

MULTI CH INPUT LINE VIDEO-1/2

POWER

ON OFF

ED-205

T-405R(Tuner)

A-909/A-909 LTD/A-905(Amplifer)

MD-105(MD Recorder)

C-705/C-705 LTD(CD Player)

If your system is totally configured with ONKYO separate collection series components, you can use the system functions using the ED-205's supplied remote controller.

Connect all components in series using the z cables, starting with the amplifier. For components having two z REMOTE CONTROL jacks, you may use either of them because their functions are same.

•If your system already has been set up with the ONKYO separate collection series components, connect the ED-205's z REMOTE CONTROL jack to the CD player's or tuner's unused z REMOTE CONTROL jack.

•To operate the system components, point the remote controller toward the amplifier's remote control sensor.

•To operate the ED-205, point the remote controller toward the ED-205's remote control sensor.

Notes:

•Do not use the z REMOTE CONTROL jack to connect products not bearing the z symbol. Doing so may result in the damage to the equipment.

•Connecting only the z cables is not sufficient for operation of your system. Connect the components also via audio connection cables.

•Connect the speaker cables before you connect the z cables.

Connecting the power

STANDBY indicator

STANDBY/ON button

Before plugging in the unit, confirm that all connections have been made properly.

Turning on this unit’s power may cause a momentary power surge, which might interfere with other electrical equipment, such as computers. If so, use a wall outlet on a different circuit.

AV SURROUND PROCESSOR

MASTER VOLUME

After plugging the ED-205’s power cord into an AC outlet, press the POWER switch to put the unit in power-standby status (the

EFFECT

MODE

STANDBY/ON

 

STANDBY

MULTI CH INPUT LINE VIDEO-1/2

POWER

ON OFF

ED-205

POWER switch

SATNDBY indicator is lit). The remote controller cannot be used to operate the ED-205 if the POWER switch is not set ON.

When the POWER switch is set ON, pressing the STANDBY/ ON button or the POWER button on the remote controller switches the ED-205 between standby status (the STANDBY indicator is lit) and power on status (the display is lit).

Press the POWER switch on the ED-205 to set it to the OFF position, turning of the unit.

10