Onkyo HTP-360, HT-R340, HT-S3100 Digital Input Signal Formats, Correcting Sound and Picture Sync

Advanced Setup—Continued

Digital Input Signal Formats

The following table shows the display indicators for each supported digital signal format.

Format	Display
Dolby Digital
DTS
PCM		PCM

Normally, the AV receiver detects the signal format auto- matically. However, if you experience either of the fol- lowing issues when playing PCM or DTS material, you can manually set the signal format to PCM or DTS:

•If the beginnings of tracks from a PCM source are cut off, try setting the format to PCM.

•If noise is produced when fast forwarding or reversing a DTS CD, try setting the format to DTS.

							TUNING	/ PRESET	MASTER VOLUME
STANDBY/ON
							ENTER
	STANDBY
A SPEAKERS B	TONE	+	STEREO	LISTENING MODE	DISPLAY DIGITAL INPUT	RT/PTY/TP MEMORY TUNING MODE	RETURN	SETUP

						CLEAR
PHONES
MULTl CH	DVD	VIDEO 1/VCR	VIDEO 2	VIDEO 3	TAPE	TUNER	CD

DIGITAL INPUT

Correcting Sound and Picture Sync

When using progressive scanning on your DVD player, you may find that the picture and sound are out of sync. With this setting, you can correct this by delaying the audio signals. You can set it to 0, 20, or 40 milliseconds.

ON/STANDBY

REMOTE MODE

RECEIVER DVD	RECEIVER
TAPE

INPUT SELECTOR

INPUT	1	2	3	CD
	V1	V2	V3
SELECTOR
	4	5	6	MD
		MULTI CH	DVD
	7	8	9	CDR
	TAPE	TUNER	CD
	+10	0	CLR	HDD
	--/---	DIMMER	SLEEP
			CH	VOL
			DISC
			ALBUM
	TOP MENU			MENU
	SP A / B			MUTING
		ENTER
	PLAYLIST			PLAYLIST
	RETURN			SETUP

1	Press the [RECEIVER] REMOTE
RECEIVER	MODE button.

1	Press and hold the AV receiver’s [DIGITAL
	INPUT] button for about 3 seconds.
2	While “Auto” is displayed (about 3 sec-
	onds), press the [DIGITAL INPUT] button

again to select: PCM, DTS, or Auto.

DTS or PCM: The DTS or PCM indicator, depending on which format you have set, flashes, and only signals in that format are output. Digital signals in other formats are ignored.

2

V1 V2 V3

DVD

Press and hold, for more than 4 seconds, the input selector but- ton for the input source that you want to correct.

This can be the [DVD], [VIDEO 1], [VIDEO 2], or [VIDEO 3] input source.

Auto (default): The format is detected automati- cally. If no digital input signal is present, the cor- responding analog input is used instead.

3 Use the Left and Right []/[ ] buttons to set the delay to 0, 20, or 40 milliseconds.

The previous display reappears if you don’t do anything for 5 minutes.

Note:

•This setting is not available when the Direct listening mode is used with an analog input signal.

57